- targetTarget value to locate.
C++ Type:double
Description:Target value to locate.
- end_pointEnd point of the sampling line.
C++ Type:libMesh::Point
Description:End point of the sampling line.
- depth36Maximum number of bisections to perform.
Default:36
C++ Type:unsigned int
Description:Maximum number of bisections to perform.
- tol1e-10Stop search if a value is found that is equal to the target with this tolerance applied.
Default:1e-10
C++ Type:double
Description:Stop search if a value is found that is equal to the target with this tolerance applied.
- vVariable to inspect
C++ Type:std::vector
Description:Variable to inspect
- execute_onTIMESTEP_ENDThe list of flag(s) indicating when this object should be executed, the available options include NONE, INITIAL, LINEAR, NONLINEAR, TIMESTEP_END, TIMESTEP_BEGIN, FINAL, CUSTOM.
Default:TIMESTEP_END
C++ Type:ExecFlagEnum
Description:The list of flag(s) indicating when this object should be executed, the available options include NONE, INITIAL, LINEAR, NONLINEAR, TIMESTEP_END, TIMESTEP_BEGIN, FINAL, CUSTOM.
- start_pointStart point of the sampling line.
C++ Type:libMesh::Point
Description:Start point of the sampling line.
FindValueOnLine
under construction:Undocumented Class
The FindValueOnLine has not been documented, if you would like to contribute to MOOSE by writing documentation, please see Documenting MOOSE. The content contained on this page explains the typical documentation associated with a MooseObject; however, what is contained is ultimately determined by what is necessary to make the documentation clear for users.
Find a specific target value along a sampling line. The variable values along the line should change monotonically. The target value is searched using a bisection algorithm.
Input Parameters
- enableTrueSet the enabled status of the MooseObject.
Default:True
C++ Type:bool
Description:Set the enabled status of the MooseObject.
- use_displaced_meshFalseWhether or not this object should use the displaced mesh for computation. Note that in the case this is true but no displacements are provided in the Mesh block the undisplaced mesh will still be used.
Default:False
C++ Type:bool
Description:Whether or not this object should use the displaced mesh for computation. Note that in the case this is true but no displacements are provided in the Mesh block the undisplaced mesh will still be used.
- outputsVector of output names were you would like to restrict the output of variables(s) associated with this object
C++ Type:std::vector
Description:Vector of output names were you would like to restrict the output of variables(s) associated with this object
- control_tagsAdds user-defined labels for accessing object parameters via control logic.
C++ Type:std::vector
Description:Adds user-defined labels for accessing object parameters via control logic.
- allow_duplicate_execution_on_initialFalseIn the case where this UserObject is depended upon by an initial condition, allow it to be executed twice during the initial setup (once before the IC and again after mesh adaptivity (if applicable).
Default:False
C++ Type:bool
Description:In the case where this UserObject is depended upon by an initial condition, allow it to be executed twice during the initial setup (once before the IC and again after mesh adaptivity (if applicable).
- force_preauxFalseForces the GeneralUserObject to be executed in PREAUX
Default:False
C++ Type:bool
Description:Forces the GeneralUserObject to be executed in PREAUX